Jump-Starting - Yamaha YXZ 1000RSS Owner's Manual

3
1. Positive battery lead (red)
2. Negative battery lead (black)
3. Battery
3. Install the battery holding plate by install-
8 ing the bolts.
4. Install the panel.
TIP
 Make sure the battery leads are installed as
shown.
 Fully charge the battery before installing it.
1
2
EBU35244

Jump-starting

Jump-starting the vehicle should be avoided.
The battery should be removed and charged
instead.
EWB03430
WARNING
To avoid battery explosion and/or serious
damage to the electrical system:
 Do not connect the negative lead of the
jumper cable to the negative terminal of
the battery.
 Do not touch the positive lead of the
jumper cable to the negative lead.
 Do not reverse the polarity of the jumper
cables when connecting to the batteries.
However, if the vehicle must be jump-started,
proceed as follows.
1. Turn the key to "
2. Remove panel A. (See page 8-11.)
3. Remove the passenger seat cushion.
(See page 4-26.)
8-61
" (off).