Yamaha YXZ 1000RSS Owner's Manual page 76

3. Tighten the locknut to the specified
torque. NOTICE: Always tighten the
locknut against the adjusting nut, and
then tighten it to the specified torque.
[ECB00082]
Tightening torque:
4
Locknut:
41 N·m (4.1 kgf·m, 30 lb·ft)
Crossover setting (YXZ10YESJ)
The crossover setting adjusts the timing when
the shock absorber transitions from the soft
spring to the hard spring.
TIP
 It is recommended to adjust the crossover
setting a similar distance whenever the
spring preload is adjusted.
 The crossover setting is measured from the
bottom of the spring preload adjusting ring
to the bottom of the crossover adjusting
ring.
1. Distance B
2. Crossover locknut
3. Crossover adjusting nut
1. Loosen the crossover locknut as shown.
4-48
2
1
3