Fan/Heat Sink Assembly - HP Mini 210-2100 Maintenance And Service Manual

Fan/heat sink assembly

Description
Fan/heat sink assembly (includes replacement thermal material)
NOTE: To properly ventilate the computer, allow at least a 7.6-cm (3-in) clearance on the left side of
the computer. The computer uses an electric fan for ventilation. The fan is controlled by a
temperature sensor and is designed to turn on automatically when high temperature conditions exist.
These conditions are affected by high external temperatures, system power consumption, power
management/battery conservation configurations, battery fast charging, and software requirements.
Exhaust air is displaced through the ventilation grill located on the left side of the computer.
Before removing the fan/heat sink assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
b. Service access cover (see
Remove the fan/heat sink assembly:
1. Turn the system board upside down.
2. Disconnect the fan cable (1) from the system board.
3. Remove the 2 Phillips 2.0x3.0 screws (2) and loosen the 2 Phillips 2.0x4.0 captive screws (3)
that secure the fan/heat sink assembly to the system board.
Battery on page 33).
Service access cover on page
Spare part number
622330-001
36).
Component replacement procedures 61