Removing Or Replacing The Vanity Cover; Removing The Vanity Cover; Replacing The Vanity Cover - HP Mini 210-2000 Getting Started

Removing or replacing the vanity cover

CAUTION:
Save your work and shut down the computer before adding or replacing a memory module, hard
drive, or SIM.
If you are not sure whether the computer is off or in Hibernation, turn the computer on by pressing the
power button. Then shut down the computer through the operating system.

Removing the vanity cover

Remove the vanity cover to access the memory module slot, hard drive, SIM card insertion slot,
regulatory label, and other components.
To remove the vanity cover:
1. Remove the battery (1) (see
2. Slide the release button (2) inward to release the vanity cover.
3. Lift the bottom edge (3) of the vanity cover, and then remove it from the computer (4).

Replacing the vanity cover

Replace the vanity cover after accessing the memory module slot, hard drive, SIM card insertion slot,
regulatory label, and other components.
To replace the vanity cover:
1. Insert the 4 tabs on the front edge of the vanity cover into the 4 slots in the base (1).
2. Rotate the back edge (2) of the vanity cover toward you, and then firmly press it down until it
snaps into place.
40 Chapter 6 Maintenance
To prevent information loss or an unresponsive system:
Removing the battery on page 39).