Connecting To Nmea 2000 Interface; Configuring The Tlm100; Figure 6 - Tlm100 Connections; Figure 7 - Nmea 2000 Connector Face Views - Maretron TLM100-01 User Manual

Cable to NMEA 2000
Sensor
Connector
Component
Figure 6 – TLM100 Connections
®
2.5.1 Connecting to NMEA 2000 Interface
®
The Maretron TLM100 provides a connection to an NMEA 2000 interface through a five pin
®
male connector (see Figure 7). You connect the TLM100 to an NMEA 2000 network using a
® ®
Maretron NMEA 2000 cable (or an NMEA 2000 compatible cable) by connecting the female
end of the cable to the TLM100 (note the key on the male connector and keyway on the female
connector). Be sure the cable is connected securely and that the collar on the cable connector
®
is tightened firmly. Connect the other end of the cable (male) to the NMEA 2000 network in the
®
same manner. The TLM100 is designed such that you can plug or unplug it from an NMEA 2000
network while the power to the network is connected or disconnected. Please follow
®
recommended practices for installing NMEA 2000 network products.
Figure 7 – NMEA 2000
®
Connector Face Views

3 Configuring the TLM100

The TLM100 has several configurable parameters, which are shown below including the default
values. If you are not using the default values, then you will need to refer to the corresponding
section for configuring the TLM100 appropriately.
Revision 1.5 Page 11