Westinghouse WTB4604S User Manual page 27

Refrigerator operation
CONCERN
Appliance will not run
It is normal for the freezer fan not to
operate during the automatic defrost
cycle, or for a short time after the
appliance is switched on.
Compressor motor seems to run
too long
At normal room temperatures, expect
your motor to run about 40% to 80%
of the time. Under warmer conditions,
expect it to run even more often.
The exterior of the appliance is warm
or hot to touch
This is normal because the appliance
transfers heat from the inside out
through the outer panels and the
divider between the doors.
User interface will not respond
To ensure settings are not accidentally
changed the user interface will go into
sleep mode when not in use. Press any
button to wake user interface
Alarms Sounding
Frost build up
Odours
Lights not working
The LED lighting is designed to turn
on gradually. The LED lighting is
designed to dim automatically if the
door is left opened for more than 5
minutes and turn off completely if the
door is open for more than 7 minutes.
Closing the door will reset the timer.
WHAT TO DO
Ensure that the cord is plugged into a live power outlet and outlet is
switched on.
Ensure that the household circuit breaker has not tripped or that the fuse
has not blown.
The appliance maybe in defrost mode, check again in half an hour.
Ensure that the doors are not held open
Check that large amounts of warm food have not just been placed inside
the appliance.
Note that the appliance will run more than normal just after you install it or
when adjusting to temperature setting changes.
Ensure the appliance has the external clearances recommended in the
section "Installing your new appliance".
The exterior of the cabinet will be much warmer on warmer days it may
even feel hot to touch, as the appliance is working harder.
Check that the user interface is in awake mode, refer to section "About the
user interface".
Check that the user interface is not locked, refer to section "About the
user interface".
If the user interface is frozen turn the appliance off for five minutes for the
memory to clear, then turn back on.
Check that the user interface is not in Sabbath Mode, refer to control
instructions. (I&W models only).
Check that all doors are fully closed.
Ensure that the over temperature alarm is not being activated by hot food
placed in the freezer.
Check if the drinks timer has ended, refer control instructions.
Check if the Filter Replacement alert is activated, refer control instructions.
(I&W models only)
Check that all doors are fully closed.
Ensure that the doors are not opened too often.
Ensure that the return air vents are not blocked with packaging.
Ensure the seals are clean and not obstructed.
The interior may need cleaning, refer to cleaning guide.
Ensure that food is stored correctly as some food, containers and
wrapping can produce odours.
Check appliance for old or unusual food.
Ensure that the cord is plugged into a live power outlet and outlet is
switched on.
Ensure that the household circuit breaker has not tripped or that the fuse
has not blown.
Check that the user interface is not in Sabbath Mode, refer to control
instructions.
Check the appliance features section to determine lighting configuration
for your model.
27
TROUBLESHOOTING