Table of Contents
Advertisement
Operating Controls
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
•
If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air condi-
tioner from blowing a fuse or tripping a circuit breaker.
•
Do not try to operate your air conditioner in the cooling
mode when outside temperature is below 61°F (16°C).
Do not try to operate your air conditioner in the heating
mode when outside temperature is over 86°F (30°C).
NOTES:
1.
NOTE: Factory default setting is for °F. To convert to
°C, press the INCREASE
simultaneously for approximately 5 seconds. To return
to °F, repeat the procedure.
2.
In the event of a power failure, your air conditioner will
operate at the previous settings when the power is
restored.
Lights next to the touch pads on the air conditioner control
panel indicate the selected settings.
The display always shows the room
The display shows the Set temperature
when in HEAT, COOL or ENERGY SAVER
temperature except when setting the Set
mode. It also shows the time remaining on
temperature or the Delay timer.
the Delay timer and the room temperature
The display always shows the room
when in Fan Only mode.
temperature except when setting the
Set temperature or the Delay timer.
Air Conditioner Controls
7
Delay 1-24 hr
4
Delay timer
-
Decrease
5
6
Mode select
5
5
Fan speed
Decrease
ON/OFF
5
3
Temperature
set Increase
and Decrease
Remote Control
/ DECREASE
buttons
Light indicates the unit is in
the temperature or delay
time Set mode.
Light indicates the unit
is in the temperature or
delay time Set mode.
Heat
Cool
Energy Saver
Fan Only
Light indicates the
delay timer is set.
4
Delay timer increase
+
5
5
Auto Fan on
Auto Fan on
5
Fan speed increase
1
Unit Power on/off
Controls
Power Pad (Button)
Turns air conditioner on and off. When turned on, the
display will show the room temperature.
Display
Shows the Set temperature when in HEAT, COOL or
ENERGY SAVER mode; shows the time remaining on
the Delay Timer; shows the room temperature when in
Fan Only mode. The SET light will turn on while set-
ting.
Temp Increase
Use to set temperature when in HEAT (on some mod-
els), COOL or ENERGY SAVER mode. The SET light
will turn on while setting.
Delay Timer Increase
Each touch of the INCREASE
on the unit or the INCREASE (+) / DECREASE (-) pads
on the remote control will set the delay time when using
the DELAY 1-24 HR timer
The SET light will turn on while setting.
Fan Speed Pads
Use to set the fan speed to LOW, MED, HIGH or AUTO,
on the unit.
NOTE: On the remote control, use the fan speed IN-
CREASE (+) / DECREASE (-) pads to set the fan speeds
to LOW, MED or HIGH. Use the AUTO pad to turn Auto
fan on.
Mode Pad
Use to set the air conditioner to COOL, ENERGY SAVER,
FAN ONLY or HEAT (on some models) mode.
Delay Pads
DELAY ON - When the air conditioner is off, it can be set
to automatically come on in 0.5 (1/2 hr.) to 24 hours at
its previous mode and fan settings.
DELAY OFF - When the air conditioner is on, it can be
set to automatically turn off in 0.5 (1/2 hr.) to 24 hours.
17
/ Decrease
Pads
(+) / Decrease
/ DECREASE
.
(-) Pads
pads
Advertisement
Table of Contents
