Bluetooth; Ypao; Volume - Yamaha R-N803 D Owner's Manual

Configuring various functions (Setup menu)
■
Update (Network Update)
Updates the firmware via the network.
Starts the process to update the unit's firmware.
Perform
For details, see "Updating the unit's firmware via
Update
the network" (p. 54).
Displays the version of the firmware installed on
Version
the unit.
Displays the system ID number.
ID

Bluetooth

Configures the Bluetooth settings.
■
On/Off
Enables/disables the Bluetooth function (p. 32).
Disables the Bluetooth function.
Off
Enables the Bluetooth function. Immediately
after selecting the "On", output of the network
On (Default)
source is paused.
■
Standby (Bluetooth Standby)
Selects whether to enable/disable the function that turns
on the unit from Bluetooth devices (Bluetooth standby). If
this function is set to "On", the unit automatically turns on
when a connect operation (p. 32) is performed on the
Bluetooth device.
Disables the Bluetooth standby function.
Off
Enables the Bluetooth standby function. (The
unit consumes more power than when "Off" is
On (Default)
selected.)
Note
This setting is not available when "Standby (Network Standby)"
(p. 49) is set to "Off".
50
En

YPAO

Configures the setting related to YPAO.
The following settings are available for each speaker
system (Speaker A, Speaker B, Speaker A+B).
Note
The corresponding speaker system and following settings will be
selectable after the YPAO measurement result is saved.
■
YPAO On/Off
Enables/disables the reflection of the YPAO measurement.
Disables the reflection of the YPAO measurement.
Off
Enables the reflection of the YPAO measurement.
On (Default)
■
VOL (YPAO Volume)
Enables/disables the YPAO volume function. When the
YPAO Volume function is enabled, the high- and low-
frequency levels are automatically adjusted according to
the volume so that you can enjoy natural sounds even at
low volume.
Disables the YPAO Volume function.
Off
Enables the YPAO Volume function.
On (Default)
Note
• The YPAO Volume function is disabled when "YPAO On/Off"
is set to "Off".
• When the YPAO volume function is enabled, the YPAO VOL.
indicator on the front display lights up.
• The LOUDNESS control (p. 24) does not function when the
YPAO Volume function is enabled.

Volume

Configures the volume-related settings.
■
Max Volume
Sets the maximum volume to prevent excessive loudness.
Setting range
-30 dB to +15.0 dB / +16.5 dB (5 dB step)
Default
+16.5 dB
■
Initial Volume
Sets the initial volume when the receiver is turned on.
Setting range
Off, Mute, -80.0 dB to +16.5 dB (0.5 dB Step)
Default
Off