Denon AVR-X1600H Owner's Manual page 239

Contents Connections
Audyssey MultEQ ® XT, Audyssey Dynamic EQ
These cannot be selected when you have not performed Audyssey
0
Switch to a sound mode other than "Direct". (v p. 132)
0
These cannot be selected when sound mode is "DTS Virtual:X" or sound mode that have "+Virtual:X" in the sound mode name.
0
These cannot be selected when using the headphones.
0
"Restorer" cannot be selected.
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
0
surround, "Restorer" cannot be used. (v p. 168)
Switch to a sound mode other than "Direct". (v p. 132)
0
No sound is output when using ZONE2.
Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL) cannot be played back. Use analog connections.
0
When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a
0
range of about 30 m.
Front panel Display
Playback
® and Audyssey Dynamic Volume
Setup. (v p. 188)
®
239
Rear panel
Settings Tips
® cannot be selected.
Remote Index
Appendix