Table of Contents
Advertisement
R-774(A)_ENG_091204:R-774(A) 2009-12-21 오후 2:21 페이지 24
Programming a macro function
• The macro function enables you to program a series
of button operations(up to 15) on this remote control
into a single button.
• You can store up to three separate macro command
sequences into "M1", "M2" and "M3" buttons.
1.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 20 to select the macro
mode ("MACRO").
• Then "M1" is displayed on the LCD screen for several
seconds.
• During macro setting operation, pressing any of the
DEVICE buttons cannot exit from the macro mode.
2.
While "M1" is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the MACRO
button to be programmed into, then press the
ENTER button.
• Each time the CURSOR UP(
pressed, "M1", "M2" or "M3" is selected.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above step 1.
All manuals and user guides at all-guides.com
▲
▼
)/DOWN(
) buttons are
24
3.
While "SEL" is flickering, press the operation
buttons you want to program in order.
Example: When playing a BD on the BD player connected
to VIDEO 2 jacks of this receiver.
①
. Press "AVR" button to control this receiver.
②
. Press "POWER ON" button to turn this receiver on.
③
. Press "VIDEO 2(7)" button to select the desired input
source.
④
. Press "BD" button to control the BD player.
⑤
. Press "POWER ON" button to turn the BD player on.
⑥
▶
. Press "PLAY (
)" button to start playback.
• Each time the operation buttons are pressed, the
programmed order is displayed.
4.
Press any of the MACRO buttons (M1~M3) to
complete the programming.
• Then "OK" is displayed.
■
To erase a macro program
• When erasing a macro program, perform the above
steps 1, 2 and 4, but ignore the step 3.
■
To change a macro program
• When a new macro program is stored into a MACRO
button with performing the above steps 1 to 4, the
previous macro program is erased from the memory of
the MACRO button.
Advertisement
Table of Contents
