Using Functions Of Remote Control - Sherwood R-774 Operating Instructions Manual

R-774(A)_ENG_091204:R-774(A) 2009-12-21 오후 2:21 페이지 20

UsInG FUnctIons oF ReMote contRoL

• This remote control can control up to 8 different components.
• Before operating audio and video components other than this receiver with using this remote control, the setup code for each
component should be entered.
• For system remote control operation, "000" was stored previously in the memory of the device button "DOCK" for Sherwood iPod
dock, "CD" for Sherwood CD player, "BD" for Sherwood BD/DVD player and "TV" for Sherwood TV respectively as its factory
setup code. So, you don't need to enter its code for each Sherwood component except in such a case that its code does not work.
■Note :
• If the transmission signal which this remote control emits is changed into "RF"(Radio Frequency), this remote control cannot
control other audio and video components. (For details, refer to "Changing the transmission signal" on page 28.)
Entering a setup code
• Setup code entry is the easiest way to program this remote
control for operating audio and video components.
1.
Turn on the component you want to operate.
2.
Find the setup codes according to the type and
the brand name of your component, referring to
"Setup Code Table" on page 74.
3.
Press and hold down both the ENTER button
and the desired one of the DEVICE buttons for
more than 2 seconds.
• Then "LEARN" is displayed on the LCD screen for
several seconds.
■
Notes :
• The "AVR" button is unavailable for the audio
components other than this receiver.
• During setting operation, to exit from the setting mode,
press any of the DEVICE buttons.
All manuals and user guides at all-guides.com
20
4.
While "LEARN" is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the setup
code mode ("CODE"), then press the ENTER
button.
• Each time the CURSOR UP(
pressed, the mode changes as follows :
→ LEARN ↔ RF-IR ↔ DELETE ↔ MACRO ←
→ CODE ↔ PUNCH ←
• Then "PRESET" and 3 digit number are displayed.
• If "PRESET", etc. go off, start again from the above step 3.
5.
While "PRESET", etc. are displayed, enter a 3
digit code and press the ENTER button.
Example: When entering "001".
• Then "OK" is displayed on the LCD screen.
• To be sure that the setup code is correct, press the
POWER ON (or STANDBY) button, aiming the remote
sensor on the component.
• If the setup code is correct, your component will be turned
off.
• When your component is not turned off, repeat the above
steps 2 to 5, trying entering each code for your component
until you find one that works.
• If "NG" is displayed, retry entering the correct setup code
while "PRESET" and 3 digit number are displayed.
▲ ▼
)/DOWN( ) buttons are