tool. Do not use a power tool while you are GENERAL POWER TOOL SAFETY WARNINGS tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious WARNING personal injury. Read all safety warnings and all instructions.
or binding of moving parts, breakage of parts ■ Always assume that the tool contains nails. and any other condition that may affect the Careless handling of the nailer can result in unexpected power tool’s operation. If damaged, have the firing of nails and personal injury.
Page 9
Z89.1-1997 is used. OPERATION ■ Keep fingers away from trigger when not driving ■ Do not use tool if trigger does not actuate properly. fasteners to avoid accidental firing. Any tool that cannot be controlled with the trigger is dangerous and must be repaired. ■...
not place second hand on top of tool or near exhaust ■ Furniture at any time. Failure to heed this warning can result in NOTE: Some timbers (such as very dry hardwood) may serious personal injury. require shorter nails to fully drive in. ■...
Page 11
Dry-fire lockout WARNING The dry-fire lockout feature keeps the tool from operating To prevent accidental starting that could cause serious when nails are low in the magazine to prevent missing nails personal injury, always remove the battery pack from the in the nail pattern and extend tool life.
Page 12
Remove the battery. Remove the pad by pulling it down ■ Turn the depth of drive adjustment left or right to change and away from the nose. To replace the pad, fit it into place the driving depth. over the nose and push up to reseat. ■...
■ Remove battery pack from the tool. BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING ■ To remove a strip of nails from the tool, depress the magazine release button located at the rear of the WARNING magazine and slide the magazine open. Upon removal, cover the battery pack’s terminals with ■...
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Work-contacting element does not depress Nails are low. Replenish the nails. fully - tool does not operate. Work-contacting element is jammed. Remove the battery and clear the debris. Tool operates properly, but fasteners are Air pressure is too low. Increase the air pressure.