Table of Contents
Advertisement
to level the cabinet using the front rollers:
1 open both doors and remove the toe grille (see "toe
Grille Installation and removal" in the "Installation"
section).
2 Close the doors and use a flat-blade screwdriver or
inch socket wrench to raise or lower the front rollers.
3 ensure both doors are bind-free with their seals touching
the cabinet on all four sides.
to level the doors using the adjustable lower hinge:
NOTE
Some models will not have a set screw. for those models
follow steps 2 through 4.
1 Before leveling either door, remove set screw that locks
door height into position. (The door cannot be adjusted
without set screw removed).
2 If the refrigerator door is lower than the freezer door,
raise the refrigerator door by turning the adjustment
screw clockwise using a
illustration.)
3 If the freezer door is lower than the refrigerator door,
raise the freezer door by turning the adjustment screw
clockwise using a
/
7
16
4 after leveling, verify door stop contacts lower hinge and
top of door does not contact upper hinge through full
movement of door (from fully closed to fully open).
5 reinstall set screw, locking the door height.
INStALLAtIoN
/
inch wrench. (See
7
16
inch wrench. (See illustration.)
7/16" Wrench
and 3/32" Hex Key
(some models)
/
3
8
6 replace the toe grille by fitting it into place (see "Toe
grille Installation and removal" in the "Installation"
section).
5
Open Door
Door Stop
Flange
Hinge
Flange
Set Screw
(some models)
Hinge
Advertisement
Table of Contents
