Siemens SIMATIC NET SCALANCE W M766-1 Series Reference Manual page 41

Industrial wireless lan approvals scalance w700 802.11ax
Hide thumbs Also See for SIMATIC NET SCALANCE W M766-1 Series:
Table of Contents

Advertisement

cULus Approval Hazardous Location
cULus Listed I. T. E. for HAZ. LOC.
Underwriters Laboratories Inc. complying with
• UL 121201 (Non Incendive electrical equipment) approved for use in Class I, Division
2, Groups A, B, C, D, T4.
• UL CSA C22.2 NO 213 (Non Incendive electrical equipment) approved for use in Class
I, Zone 2, Group IIC, T4.
FCC approval
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
___________________________________________________________________________
Notice
Changes or modifications made to this equipment not expressly approved by SIEMENS
may void the FCC authorization to operate this equipment.
___________________________________________________________________________
IEEE 802.11b or g operation of this product in the USA is firmware-limited to channels 1
through 11.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Approvals SCALANCE W700 802.11ax
Reference Manual, 03/2022, C79000-G8976-C621-03
SCALANCE WxM763-1
2.5 General approvals
41

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simatic net scalance w m763-1 series

Table of Contents