Adjustment Of System Control; System Clock 27 Mhz Adjustment; Adjustment Of Video System; Video Level Adjustment - Sony RMT-D107A Service Manual

7-2. Adjustment of System Control

1. System Clock 27 MHz Adjustment (MB-84 board)
<Purpose>
27 MHz is the reference clock for the MPEG system, and if it is
not adjusted correctly, checking of 22 MHz and 33 MHz lock in
the following steps will result in NG.
Mode E-E
IC206 8 pin
Test point
Instrument Oscilloscope, Frequency counter
Adjusting element CT201
Specification 27000000 ± 100 Hz
Adjusting method:
1) Confirm that the waveform at TP018 is normal.
2) Adjust CT201 to attain 27000000 ± 100 Hz.
Figure 7-1

7-3. Adjustment of Video System

1. Video Level Adjustment (MB-84 board)
<Purpose>
This adjustment is made to satisfy the NTSC standard, and if not
adjusted correctly, the brightness will be too large or small.
Video Encoder (IC252) check in test
Mode
mode menu "0" Syscon Diagnosis
Signal Color bars
LINE OUT (VIDEO) connector
Test point
(75 Ω terminated)
Instrument Oscilloscope
Adjusting element RV251
Specification 1 ± 0.02 Vp-p
Adjusting method:
1) In the test mode initial menu "0" Syscon Diagnosis, set so that
Video Encoder (IC252) color bars are generated.
2) Adjust the RV251 to attain 1 ± 0.02 Vp-p.
Figure 7-2
2. S-terminal Output Check (MB-84 board)
<Purpose>
Check S-terminal video output. If it is incorrect, pictures will not
be displayed correctly in spite of connection to the TV with a S-
terminal cable.
Mode
Signal
Test point
Instrument
Specification
Checking method:
1) In the test mode initial menu "0" Syscon Diagnosis, set so that
Video Encoder (IC252) color bars are generated.
2) Confirm that the S-Y level is 1 ± 0.05 Vp-p.

3. Checking Component Video Output B-Y

(MB-84 board)
<Purpose>
This checks component video output B-Y. If it is incorrect, cor-
rect colors will not be displayed when connected to, for instance,
projector.
Mode
Signal
Test point
Instrument
Specification
Checking method:
1) Confirm that the B-Y level is 700 ± 30 mVp-p.
1 ± 0.02 Vp-p
7-2
Video Encoder (IC252) check in test
mode menu "0" Syscon Diagnosis
Color bars
S VIDEO OUT (S-Y) connector
(75 Ω terminated)
Oscilloscope
1 ± 0.05 Vp-p
1 ± 0.05 Vp-p
Figure 7-3
Video Encoder (IC252) check in test
mode menu "0" Syscon Diagnosis
Color bars
COMPONENT VIDEO OUT (B-Y)
connector (75 Ω terminated)
Oscilloscope
700 ± 30 mVp-p
700 ± 30 mVp-p
Figure 7-4