Table of Contents
Advertisement
Install the batteries
Use batteries type UM3 (AA-Size).
Do not use old or weak batteries. The remote control may not work properly with a weak voltage from such
batteries. Replace exhausted batteries with new ones. Never try to recharge normal batteries - this could
cause an explosion.
Note:
Exhausted batteries can leak corrosive electrolyte, which may cause damage to the remote control -
therefore remove exhausted batteries immediately.
1
Open the battery
compartment.
Distance of Remote Control Operation
The remote control handset will not work properly in the following cases:
If bright sunlight directly beams onto the unit front.
If the batteries have not been installed according to
their polarities.
51B0346B_ENG.indd 9
51B0346B_ENG.indd 9
2
Install the batteries as shown
below, ensuring the correct
polarity.
Remote sensor
Maximum distance approx. 5m
Transmitter window
Remote Control
3
Close the battery
compartment.
Point the remote control
directly at the remote sensor.
30
30
If an obstacle is placed between the unit and the
handset.
If the batteries are weak.
9
6/13/08 10:07:21 AM
6/13/08 10:07:21 AM
Advertisement
Table of Contents
