Table of Contents
Advertisement
14. KNIFE PRESSURE
CAUTION : Switch off the main switch before adjustment.
a) Remove left and right cloth clamp plats.
b) Loosen the nut ① and the adjustment screw ②.
c) Pull the knife driving release knob③, rotate it clockwise until mark (B) align to the mark (C).
d) Tighten the screw ② with your hand until the pressure can be felt and tighten the nut ① with spanner.
Never tighten the screw ② too strong/high pressure. The cutting block pressure should adjust as low as
possible to prevent any damage to the surface of cutting block or knife.
CAUTION :
If the knife pressure is too strong/high pressure, surface of knife or cutting block is damaged or safety cap
will be broken to prevent the cutting block arm broken. In case of that, re-adjust the knife pressure in
accordance with above a) ~ d) very carefully.
e) After adjusting d), rotate the knob ③ counter-clockwise until the mark (B) align to the mark (A). It is
original position.
NOTE: If you cannot achieve the perfect cutting even the knife pressure is properly, file/dress up a surface of
cutting block carefully.
Cutting block
Knife
②
①
(B)
(C)
c)
Pull the knob ③ to the left
and keep it.
③
c)
Rotate the knob ③ clockwise
(A)
until the mark (B) align to the
mark (C).
d)
When the mark (B) and (C) is
align, tighten the screw ②
with hand for knife pressure
adjusting, tighten the nut ①
(B)
and rotate the knob ③ until
the mark (B) and (A) is align
(original position).
10
Advertisement
Table of Contents
