Heatilator CNXT4236IFTT Owner's Manual page 15

- Wait five (5) minutes to allow possible
accumulated gas to clear.
- Set the IFT-ECM 3-position selector switch to ON
or REMOTE position. Module will beep once and
flash a three GREEN LED code on successful
startup.
- If placed in ON position, the appliance will ignite
normally if the error condition was corrected.
- If placed in REMOTE position, use the paired IFT-
RC400, IFT-RC150 or wired wall switch to start
the appliance; appliance will ignite normally if the
error condition was corrected.
- If the IFT-ECM re-enters the lock-out condition
after these steps, call your dealer for service.
Heatilator • CNXT4236IFT, CNXT4842IFT Owner's Manual • 2515-981 Rev. L • 12/20
IntelliFire Touch Ignition System
NOTICE: Batteries should not be placed in the battery
pack while using the transformer. Remove batteries before
using the transformer, and unplug the transformer before
installing the batteries. Battery polarity must be correct or
module damage will occur.
Appliance ON/OFF:
This model is supplied with a fully functional remote
control. This remote controls:
• ON/OFF Functions
• Flame height adjustments
• Thermostat
• Cold Climate Feature
• Fan Speed
• Optional Heat Management Systems
Please refer to the instructions included with the remote
control for more detailed operating instructions.
Heat Management Systems
®
Optional Heat-Zone -Gas Kit
®
The Heat-Zone -Gas heat management option is avail-
able for use with the CNXT4236IFT and CNXT4842IFT
appliances. The Heat-Zone
your fireplace to an adjacent room in your home, up to
20 feet away.
Optional Heat-Out-Gas Kit
The Heat-Out-Gas heat management option is available
for use with the CNXT4236IFT and CNXT4842IFT and
must be used in conjunction with the IFT-RC400 remote
control. The Heat-Out-Gas kit draws heat from your
fireplace and directs it outside, up to 25 feet away.
Optional Heat-Duct Kit
The Heat-Duct heat management option is available
for use with the CNXT4236IFT and CNXT4842IFTH
appliances. The Heat-Duct redistributes heat from the
fireplace via the furnace ductwork.
® -Gas Kit draws heat from
15