Technical Data - Zanussi ZWY 50904WA User Manual

Problem
There is water on the floor.
You cannot open the appli-
ance lid.
The appliance makes an un-
usual noise.
The appliance fills with water
and drain immediately.
The washing results are not
satisfactory.
You cannot set an option.
After the check, activate the appliance. The
programme continues from the point of
interruption.
If the problem occurs again, contact the
Authorised Service Centre.
If the appliance shows other alarm codes (the
indicator of button
Deactivate and activate the appliance. If the
problem continues, contact the Authorised
Service Centre.

Technical Data

Dimension
Electrical connection
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except where the
low voltage equipment has no protection against moisture
16
• Make sure that the couplings of the water hoses are tight and there is
not water leakages.
• Make sure that the water inlet hose and the drain hose have no dam-
ages.
• Make sure you use the correct detergent and the correct quantity of
it.
• Make sure that the washing programme is finished.
• Set the drain or the spin option if there is water in the drum.
• Make sure the levelling of the appliance is correct. Refer to 'Installa-
tion instruction'.
• Make sure that the packaging and/or the transit bolts are removed.
Refer to 'Installation instruction'.
• Add more laundry in the drum. The load may be too small.
• Make sure that the drain hose is in the correct position. The end of
the hose may be too low. Refer to 'Installation instruction'.
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before you wash
the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Make sure that you press only the wanted touch button(s).
flashes in red).
Width/ Height/ Depth/ Total
depth
Voltage
Overall power
Fuse
Frequency
Possible solution
Service
We recommend the use of original spare parts.
When contacting the Authorised Service
Centre, make sure that these data are available.
You can find the information on the rating plate:
model (Mod.), PNC (Prod.No.), Serial number
(Ser.No.).
400 mm/ 890 mm/ 600 mm/ 600 mm
230 V
2200 W
10 A
50 Hz
IPX4
www.zanussi.com