Troubleshooting - Zanussi ZWY 50904WA User Manual

7
Cleaning the inlet hose and the valve
filter
1
2
3

Troubleshooting

WARNING!
Refer to Safety chapters.
Introduction
The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (refer
to the table). If not, contact the Authorised
Service Centre.
14
8
9
10
CLACK
11
CLACK
90˚
Frost precautions
If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the
drain pump.
Do this procedure also when you
want to do the emergency drain.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap and disconnect the
water inlet hose.
3. Disconnect the drain hose from a sink or
spigot.
4. Put the ends of the drain and inlet hose in a
container. Let the water flow out of the
hoses.
5. Connect the mains plug to the mains socket
and activate the appliance again.
6. Set any washing cycle together with the
option "Drain and Spin" and let it operate
until the end of the cycle.
7. Press the button
appliance.
8. Disconnect the appliance from the mains
socket.
WARNING!
Make sure that the temperature is more than 0
°C before you use the appliance again. The
manufacturer is not responsible for damages
caused by low temperatures.
With some problems, the acoustic signals
operate. The indicator of button
red and one of the indicators comes on, to
show an alarm code:
• - The appliance does not fill with water
properly.
• - The appliance does not drain the water.
to deactivate the
flashes in
www.zanussi.com