Section 3: Circuit Requirements; 110V Operation - Grizzly H5697 Instruction Manual

SECTION 3: CIRCUIT REQUIREMENTS

110V Operation

Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up
process. DO NOT connect the machine to
the power source until instructed to do so.
Amperage Draw
The 1 ⁄ HP motor on the Model H5697 will draw
2
the following amps:
110V Motor Draw ....................................4 Amps
Circuit Breaker Requirements
Install your machine on a dedicated circuit to
reduce the possibility of tripping the circuit break-
er. If the circuit breaker frequently trips, have the
circuit inspected by a qualified electrician. Never
use a larger circuit breaker than stated below, or
you will increase the risk of fire.
Circuit Breaker ............................10 Amp, 1 Pole
Plug Type
The Model H5697 is supplied with a 5-15 plug,
similar to Figure 1.
Figure 1. Typical type 5-15 plug and receptacle.
-6-
Grounding
In the event of an electrical short, grounding
reduces the risk of electric shock by providing a
path of least resistance to disperse electric cur-
rent. This tool is equipped with a power cord that
has a plug with an equipment-grounding prong.
The outlet must be properly installed and ground-
ed in accordance with all local codes and ordi-
nances.
This machine must have a ground prong in
the plug to help ensure that it is grounded.
DO NOT remove ground prong from plug to
fit into a two-pronged outlet! If the plug will
not fit the outlet, have the proper outlet
installed by a qualified electrician.
Extension Cords
• Make sure the cord is rated Standard Service
(grade S) or better.
• The extension cord must also contain a
ground wire and plug pin.
• Use at least a 16 gauge cord.
• DO NOT use a cord longer that 50 feet!
H5697 Cement Mixer