Drum - Grizzly H5697 Instruction Manual

Drum

Components and Hardware Needed
Drum ..................................................................1
Spanner Nuts M24-1.5 ......................................2
Pinion Gear Safety Guard..................................1
Phillips Head Screws M5-.8 x 16 ......................2
Tools Needed:
Phillips Screwdriver............................................1
To install the drum:
Insert the drum shaft into the yoke.
1.
Thread one of the spanner nuts onto the end
2.
of the drum shaft; tighten it all the way down
by hand, then loosen it a
3. Thread on the remaining spanner nut and
tighten it against the first spanner nut (Figure
24).
-16-
Qty
1 ⁄ turn.
4
Figure 24. Spanner nuts securing drum to yoke.
Using the Phillips head screws, secure the
4.
pinion gear safety guard to the yoke, so that
it is directly over the pinion gear.
H5697 Cement Mixer