Table of Contents
Advertisement
FIG. 6
WARNING
KEEP THE TOOL POINTED AWAY FROM YOURSELF AND
OTHERS WHEN LOADING FASTENERS. FAILURE TO DO
COULD RESULT IN POSSIBLE SERIOUS PERSONAL INJURY.
NEVER LOAD FASTENERS WITH THE WORKPIECE
CONTACT OR TRIGGER ACTIVATED. DOING SO COULD
RESULT IN POSSIBLE SERIOUS PERSONAL INJURY.
REMOVING THE NAILS:
1.
Disconnect air supply.
2.
Press magazine latch and pull magazine to open
position(FIG 5).
Grasp the head of the nail strip and remove it from
3.
magazine.
METHODS OF OPERATION
This tool is equipped with the safety and does not operate
unless the safety is depressed.
The methods of operation to drive nails with this tool is
sequential actuation mechanism.
1).Position the nail outlet on the workpiece with finger off
the trigger.
2).Depress the safety firmly until it is completely
depressed.
3).Pull the trigger to drive a nail.
4).Remove finger from the trigger.
To continue nailing a separate location, move the tool
along the wood, repeating steps (2-4) as required.
Always handle nails and package carefully. If nails are
dropped, collating bent may be broken, which will cause
mis-feeding and jamming.
After nailing:
1).Disconnect air hose from the tool.
2).Remove all nails from the tool.
3).Supply 5-10 drops of pneumatic tool lubricant into
the air plug on the tool.
4).Open the petcock on the air compressor tank to drain
any moisture.
Staple
18Ga.
COLD WEATHER OPERATION
WARNING
DO NOT USE A FROZEN TOOL. Allow tool to thaw before
using. Moisture frozen in the tool may impede internal
components resulting in the risk of injury and/or tool
damage.
When using the tool in cold conditions the tool will cycle
slower than usual while driving the first nails. The cycle rate
will increase as the tool warms up. Keep tool warm to avoid
reduced cycle rate.
ADJUSTING THE NAILING DEPTH
WARNING
Disconnect the tool from the air source before making
adjustments. Such precautionary safety measures reduce
the risk or unintentional tool operation.
1.
Disconnect tool from air supply.
2.
Remove nails from the tool.
Adjust tool driving depth:
3.
To reduce the nail depth , turn the adjustment knob
counter clockwise (FIG 7).
To drive the nail deeper, turn the adjustment knob
clockwise (FIG 8).
Reload nails as described in the "Loading Nails" section
4.
of this manual.
Reconnect air supply.
5.
FIG. 7
Too Deep
Turn the adjustment knob counter clockwise
FIG. 8
Too Shallow
Turn the adjustment knob clockwise
6
Flush
Flush
Advertisement
Table of Contents
