Related Manuals for DAJ PEGD8016
Summary of Contents for DAJ PEGD8016
- Page 1 USERS MANUAL 5/8" UPHOLSTERY STAPLER MODEL: PEGD8016 WARNING Failure to follow warning could result in DEATH OR SERIOUS INJURY. M0711 08/10 V1...
-
Page 2: Table Of Contents
CONTENTS: IMPORTANT INFORMATION EXPLANATION OF THE NAILING ACTION GENERAL SAFETY RULES WORK AREA PERSONAL SAFETY TOOL USE AND CARE SERVICE AIR SOURCE DESCRIPTION AND SPECIFICATION SPECIFICATION FEATURES ASSEMBLY/INSTALLATION OPERATION LUBRICATION ADJUSTING AIR PRESSURE CONNECTING AIR SUPPLY TOOL TESTING NAIL LOADING METHODS OF OPERATION COLD WEATHER OPERATION MAINTENANCE... -
Page 3: Important Information P1
IMPORTANT INFORMATION Safety glasses must conform to the requirements of American National Standards Institute, ANSI Z87.1 and provide protection against flying particles both from the WARNING front and side. The employer must enforce the use of TO AVOID SERIOUS PERSONAL INJURY, ALL USERS AND safety glasses by the tool operator and others in work EMPLOYERS/OWNERS MUST READ AND UNDERSTAND area. -
Page 4: Air Source
TOOL SERVICE USE ONLY FASTENERS THAT ARE RECOMMENDED FOR YOUR MODELS. Do not use the wrong fasteners or load USE ONLY ACCESSORIES THAT ARE IDENTIFIED BY THE the fasteners incorrectly. MANUFACTURER FOR THE SPECIFIC TOOL MODEL CHECK FOR MISALIGNMENT OR BINDING OF MOVING USE OF UNAUTHORIZED PARTS OR FAILURE TO FOLLOW PARTS, BREAKAGE OF PARTS, AND ANY OTHER MAINTENANCE INSTRUCTIONS MAY CREATE A RISK OF... -
Page 5: Specification P3
FUNCTIONAL DESCRIPTION AND SPECIFICATIONS WARNING Disconnect the tool from the air source before making any adjustments, changing accessories o storing the tool. Such precautionary safety measures reduce the risk of unintentional tool operation. FIG. 1 Air Cap Trigger Hand Grip Air Plug Magazine Body... -
Page 6: Features P4
FEATURES If the tool is not used with an in-line lubrication system on the air supply it is necessary to periodically lubricate the Comfort-grip handle. tool with air tool lubrication. For increased comfort and control. Ergonomically engineered body. Under low use, lubricate once a day. Under heavy use, Rugged and comfortable resulting in a light weight tool lubricate twice a day. -
Page 7: Tool Testing
THE TOOL MUST NOT OPERATE. WARNING Point the tool downward, pull the trigger and then wait in Do not exceed maximum recommended air pressure that position for 5 seconds or longer. marked on the tool. Verify prior to using the tool that the air THE TOOL MUST NOT OPERATE. -
Page 8: Methods Of Operation
FIG. 6 Always handle nails and package carefully. If nails are dropped, collating bent may be broken, which will cause mis-feeding and jamming. After nailing: 1).Disconnect air hose from the tool. 2).Remove all nails from the tool. 3).Supply 5-10 drops of pneumatic tool lubricant into the air plug on the tool. -
Page 9: Cleaning P7
CLEANING With ON/OFF switch in OFF position, plug compressor into electrical outlet. WARNING Close pressure regulator by turning all the way to the When cleaning a tool be careful not to disassembly any left. Turn compressor ON and let it pump all the way up portion of the tool since internal components may be to automatic shut-off pressure. -
Page 10: Trouble Solving P8
TROUBLE SOLVING PROBLEMS POSSIBLE CAUSES SUGGESTED SOLUTIONS Air leaking near the top of 1. Loose screws. 1. Tighten screws. the tool or in the trigger 2. Worn or damaged O-rings or seals. 2. Install overhaul kit. area. Air leaking near the bottom 1.