Troubleshooting - PROFIX TRYTON TOE1601 Operating Instruction

TROUBLESHOOTING:

Problem
The device fails to switch on or works
with interruptions.
Low suction pressure or no suction
Low blowing pressure or no blowing
This instruction manual is protected by copyright. Copying it without the written consent of PROFIX Co. Ltd. is prohibited.
Possible reason
Lack of power voltage
Worn carbon brushes
On/Off trigger is defective
Defective motor
Damaged power cord
Internal electric circuits of the device are broken
Foreign bodies seized the motor
Suction pipe is not correctly connected
Operation mode selector is in wrong position
Waste bag is full
Waste bag is dirty
The device is clogged or locked by foreign
bodies
Operation mode selector is in wrong position
Rotation speed control knob is in wrong
position (only the TOE2401 version)
9
Remedies
Check voltage in the electric outlet, inspect the
power cord and call an electrician if necessary.
Hand the machine over for repair to a service
workshop.
Remove the clogging /seizing objects.
Correctly connect the two-part pipe
Rotate the selector switch to the suction position
Empty the waste bag
Clean the waste bag
Remove the clogging material
Rotate the selector switch to the blowing position
Change position of the rotation speed control knob
to high rpm