Mattel Disney PIXAR Cars TYCO T0243 Instructions page 4

Avenue, East Aurora, NY 14052, U.S.A. Consumer Relations

1-888-557-8926. Retain this address for future reference: • Mattel

U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline

01628 500303. • Mattel Australia Pty Ltd., Richmond, Victoria

3121 - Consumer Advisory Service: 1300 135 312. • Mattel East Asia

Ltd, Room 1106, South Tower, World Finance Centre, Harbour City,

Tsimshatsui, HK, China. • Diimport & Diedarkan Oleh: Mattel SEA

Ptd Ltd. (993532-P) Lot 13.5, Menara Lien Hoe, Persiaran Tropicana

Golf Country Resort, 47410 PJ. Tel: 03-78803817, Fax: 03-78803867.

service.mattel.com

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired

operation.

• This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant

to part 15 of the FCC rules. These limits are designed

to provide reasonable protection against harmful

interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that

interference will not occur in a particular installation.

If this equipment does cause harmful interference to

radio or television reception, which can be determined

by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

NOTE: Changes or modifications not expressly approved

by the manufacturer responsible for compliance could

void the user's authority to operate the equipment.