Crosley CRSE233TS0 Use & Care Manual page 11

5 With steel clamp and screw, secure water
supply line (copper tubing only) to rear
panel of refrigerator as shown.
6 Coil excess water supply line (copper
tubing only), about 2½ turns, behind
refrigerator as shown and arrange coils so
they do not vibrate or wear against any
other surface.
7 Turn ON water supply at shutoff valve and
tighten any connections that leak.
8 Reconnect refrigerator to electrical power
source.
9 To turn ice maker on, lower wire signal
arm.
Plastic Water
Tubing to Ice
Maker Fill
Tube
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Figure 1
CONNECTING THE WATER SUPPLY
Steel
Clamp
Brass
Compression
Nut
Ferrule
(Sleeve)
Copper
water line
Water Valve
Bracket
Valve Inlet
Water Valve
Copper water line
from household
water supply
Plastic Water Tubing
to Ice Maker
Fill Tube
6 ft (1.8 Meters) Braided flexible
stainless steel water line from
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Figure 2
IMPORTANT
After connecting the water supply, refer to
"How to Prime the Water Supply System"
for important information about priming an
empty water supply system.
Your refrigerator's water supply system
includes several tubing lines, a water filter,
a water valve. To ensure that your water
dispenser works properly, this system
must be completely filled with water when
your refrigerator is first connected to the
household water supply line.
Steel
Clamp
Braided
Flexible
Stainless
Water Line
Water Valve
Bracket
Valve Inlet
Water Valve
household water supply.
Steel
11