Subscribe to Our Youtube Channel
Related Manuals for Kanto SUB8V
Summary of Contents for Kanto SUB8V
- Page 1 English User Manual sub8 Sealed Powered Subwoofer SEALED POWERED SUBWOOFER Supporting your digital lifestyle ™...
-
Page 2: Important Safety Precautions
Important Safety Precautions RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE DANGEROUS VOLTAGE ATTENTION RISK OF ELECTRIC SHOCK, DO The lightning flash with arrowhead, within an The exclamation point within an NOT REMOVE BACK PANEL. equilateral triangle, is intended to alert the user equilateral triangle is intended to alert NO USER SERVICEABLE PARTS of the presence of non-insulated “dangerous... -
Page 3: What's In The Box
We recommend you read all instructions carefully before using the sub8 and keep them for future reference. Kanto cannot be liable for damage or injury caused by incorrect setup or use of this product. This powered subwoofer was carefully tested and inspected during production, and before packaging and shipping. -
Page 4: Front And Rear Panels
Front & Rear Panels FRONT PANEL 1 8” Paper Cone Driver... - Page 5 Front & Rear Panels REAR PANEL Volume Knob Low-Pass Filter Frequency Control Standby Power Phase Switch Line Level Input ON / OFF Switch AC Input Connection (100 V - 240 V)
- Page 6 Setting Up and Connecting your Subwoofer Ensure that the ON/OFF Switch is in the OFF position before connecting any component. To some degree, positioning the subwoofer is less critical because it produces only non- directional low-frequency sounds. However, best results are obtained if the subwoofer is placed either between the left and right speakers or in the vicinity of either the left channel or right channel speaker.
- Page 7 Setting up and Connecting your Subwoofer Sub Out − Volume Sub Out WOOFER PRE-OUT AUDIO COMPONENT AUDIO SURROUND VIDEO FRONT REAR SURROUND CENTER AUX INPUT WOOFER AMPLIFIER HOME THEATER RECEIVER...
- Page 8 Audio Troubleshooting Guide Frequently asked questions about Kanto’s sub8. None of the lights on the rear of the Subwoofer is going into standby while subwoofer are illuminated. listening to audio. • Set the volume of the source to its highest level. Low •...
- Page 9 www.kantoaudio.com 1-888-848-2643 support@kantoliving.com...
-
Page 10: Specifications
Specifications Woofer 8” paper cone Amplifier Type Class D Power Output 300 W peak power (150 W total RMS) Frequency Response 35 Hz – 175 Hz Low-Pass Filter 40 Hz - 120 Hz Phase Switch 0º and 180º Inputs 1 x RCA (L/R) Input Voltage / Frequency AC 100 V - 240 V 50/60 Hz Standby Power Consumption... - Page 11 YU Passive 5.25” YU Passive 4” SX22 SX26 SP32PL / SP26PL SP32PL SP32PL SP26PL SP6 / SP9HD SE6 / SE4 / SE2 S6 / S4 / S2 kantoaudio.com Kanto Audio @kantoaudio kantoaudio Kanto Audio Kanto Living...
- Page 12 The information in the manual has been carefully checked and is believed to be accurate. However, Kanto assumes no responsibility for any inaccuracies that may be contained in the manual. In no event will Kanto be liable for direct, indirect, special, incidental, or consequential damages resulting from any defect in the equipment, even if advised of the possibility of such damages.
Need help?
Do you have a question about the SUB8V and is the answer not in the manual?
Questions and answers