We recommend you read all instructions carefully before using the YURI and keep them for future reference. Kanto cannot be liable for damage or injury caused by incorrect setup or use of this product.
Front & Rear Panels FRONT PANEL 8” Paper Cone Driver Flared Bass Port REAR PANEL Volume Knob Crossover Knob Phase Switch Standby Power Line Level Input ON / OFF Switch AC Input Connection & Fuse (100 V - 240 V) Voltage Select...
Page 5
L/R subwoofer output or L/R preamplifier outputs, you can use either channel as the output to YURI. The Crossover Control is used to set the upper limit of the frequencies that YURI will reproduce within the range of 40Hz-180Hz. Refer to your manufacturer’s information for the lower cut-off frequency of your main speakers, or adjust the Low-Pass Filter frequency to your personal preference.
Standby Control AUTO: [Recommended] When no audio signal has been detected for 10 minutes, YURI will put itself into standby mode. If the audio signal returns, it will wake up and resume playing. ON: By switching the standby control to “ON”, YURI will not enter standby mode and will stay on indefinitely.
Page 7
Kanto’s YURI subwoofer was carefully tested and inspected during production and it is rare that a unit is damaged during shipping. If any issues occur during the set up of your YURI subwoofer, your questions may be answered in the Troubleshooting guide below.
24 months for parts and labour. If equipment fails because of such defects and Kanto or an authorized dealer is notified within 24 months from the date of shipment with proof of original invoice. Kanto will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanical, electrical, or other abuse or modifications.