Table of Contents
Advertisement
Troubleshooting
Check the following before requesting service.
Symptoms
Remaining time fl uctuates.
No operation.
Cannot change the operation
contents. (after start)
No water supply.
Water is supplied in the middle
of Wash process.
The water level is too high for
the amount of laundry.
The water level is too low for the
amount of laundry.
The operation started with Rinse
process, however, water is not
supplied.
The operation suddenly changes
to rinse process in the middle of
spin process./
Only spin is desired, however,
the operation starts with rinse.
Irregular rotation during spin.
Power failure./
The breaker has tripped.
Water failure.
Operation does not fi nish even
after the reservation time.
Cannot select 5 Fragrance
course.
14
14
NA-F953H̲インドネシア向洗濯機.indd 14
NA-F953H̲インドネシア向洗濯機.indd 14
Checkpoints
● Remaining time is corrected during the process and displayed.
(Time indication is an approximation.)
● Power failure?
● Is the lid closed completely?
● Is the power fuse or the breaker cut off?
● Is the power plug plugged in completely?
● Is the water faucet turned on?
● Is the "Start" button pressed?
● Has the Reserve program been set?
● The contents can be changed in Wash process by pressing "Pause". To change the
course or to change the contents after Rinse process, turn the power off and then on
again.
● Is the water faucet turned on?
● Water failure?
● Is the water supply fi lter clogged with dust? (P.11)
● When level goes down, water is supplied automatically.
● With large amount of laundry, water is supplied several times automatically.
● If the laundry is wet or if there is water in the tub before operation, the water level may
be higher.
● With light clothes (synthetic fi bre, etc.), the water level may be lower.
● If there is no water in the tub, water is supplied after spin.
● If there is water in the tub, water is supplied after water discharge.
● If the laundry is unevenly placed in the tub, the machine starts to rinse and
automatically corrects the arrangement.
(Put the laundry as evenly as possible.)
● The tub rotation speed is adjusted to reduce bubble foaming during spin.
● The operation will stop. When power is recovered, the operation will resume.
("Auto Restart" indicator lights up.)
● After water supply is recovered, remove the water supply hose to release muddy
water from the faucet, and start the operation.
● Operation time will become longer if laundry leans to one side or water supply or
drainage is ill-conditioned.
● If Child Lock (P.10) has been set,
5
Fragrance course cannot be selected.
2012/12/27 12:53:20
2012/12/27 12:53:20
Advertisement
Table of Contents
