Windshield Wipers - Chevrolet 2010 Impala Owner's Manual

If either one of the turn signals are left on and the
vehicle has been driven more than 3/4 mile (1.2 km),
a chime will sound.
To change the headlamps from low beam to high beam,
push the turn signal/multifunction lever away from you.
This instrument panel cluster light
high beam lamps are turned on while the ignition is in
ON/RUN.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.
This feature is used to signal to the vehicle ahead that
you want to pass.
If the headlamps are off or in the low beam position, pull
the turn signal lever toward you to momentarily switch
to high beams.
Release the lever to turn the high-beam headlamps off.
Turn the band with the wiper symbol to control the

windshield wipers.

Several wipes, hold the band on
more frequent wipes or down for less frequent wipes.
comes on if the
Clear ice and snow from the wiper blades before using
them. If frozen to the windshield, carefully loosen or
thaw them. Damaged wiper blades should be replaced.
See
Heavy snow or ice can overload the wiper motor.
A circuit breaker will stop the motor until it cools down.
Single wipe, turn to
Turns the windshield wipers off.
Turn the band up for
Slow wipes.
Fast wipes.
.
, then release.
longer.
4-5