Savant SHA-B7CL 00 Series Quick Reference Manual

Savant® Shade Corner Idler Left (SHA-B7CLxx-00)
Quick Reference Guide
The shade mount in the SHA-B7CLxx corner shade mount kit is a floating/outside type mount for the idler side (opposite drive motor) of a
Savant shade installation. The mount has a 45° bevel with a slot cut in the bevel so it can be joined together with any of the other corner type
mounts using an angled bracket (angled bracket is included in the SHA-B7CRxx and SHA-B8CRxx shade mount kits). The shade mounts in the
SHA-B7 and SHA-B8 shade corner mount kits are typically installed where two windows meet each other to form either an inside or outside
90° angle. As shown in the Box Contents image below, the Tube End Plug included in the kit, slides into the hole in the center of the mount. The
shade mount in the SHA-B7CLxx kit is a floating/outside type mount and is installed using the included shade mount sleeve and 2 inch hanger
bolt. Before installing this mount (idler side), Savant recommends that a drive side shade mount be installed first and then used as a reference
point for when installing this mount.
Box Contents
Shade Mount Sleeve
3/32 in. Hex Screw
Hanger Bolt
Flat Head Screw
Tube End Plug
(Female)
HELPFUL! Before starting the mounting process, review the diagram below to ensure a trouble free install.
– Install shade mount so the center point of the mount is installed at least
³/ ₄
inch (minimum) from any obstructions.
– To aid in the installation of the shade mounts, a template (SHA-INSTEMP-
xx) is available. This template contains all the holes and spacing required
to mount any of the shade mounts.
– To reduce marking up the walls, it is recommended that painters tape be
used whenever drilling is involved.
Assemble Corner Shade Mounts
The SHA-B7CR, SHA-B7CL, SHA-B8CR, and SHA-B8CL are all corner shade mounts and utilize a 90° angled joiner bracket to join any two of
these corner mounts. Once the two shade mounts are joined together, they form a 90° angle that can be used in most inside or outside corners.
The steps below describe how to join the shade mounts in the SHA-B7CLxx and SHA-B7CRxx shade mount kits but these instructions can be
used to join any of the other corner type shade mounts.
1. Grab the corner shade mount from the SHA-B7CLxx shade mount kit.
2. Grab the 90° angled joiner bracket from either the SHA-B7CRxx or SHA-
B8CRxx corner shade mount kits.
HELPFUL! Angle brackets are supplied with only the SHA-B7CRxx and
SHA-B8CRxx shade mount kits.
3. Slide the joiner bracket into the slot in the shade mount from the SHA-
B7CLxx kit. Slide bracket into the mount until it sits flush with the top of
shade mount.
SHA-B7CLxx-00 | 009-1664-00 | 180424
Copyright 2018 Savant Systems, LLC
Shade Mount
SHA-B7CLxx Front View
(1) Shade Mount - Floating/Outside Type Corner Mount
(1) Shade Tube End Plug (female)
(1) 2-inch Hanger Bolt
(1) 1 inch Shade Mount Sleeve
1/2
(1) #6 x 1 in. Flat Head Screw
(1) Quick Reference Guide (this document)
1
Slot in
shade mount
Angled part of
the shade mount
1 of 2
For Product Info
Vertical Mount
1.75 in.
(minimum)
Slide bracket into
shade mount. Slide
downward until
bracket is fully seated
Outside view
of the SHA-B7CL
45 Perseverance Way, Hyannis, MA 02601
Savant.com | 508.683.2500