Table of Contents

Advertisement

OPERATION

Control panel
Display for temperature setting
1.
The preset temperature of compartment selected is
displayed. It is not an actual temperature in the
compartment.
Display for compartment selected
2.
Select button
3.
The compartment selected can be changed by pressing
the select button.
Press the
select button
Initial display for
refrigerator compartment
/
button
4.
Use to select temperature.
button
5.
Finalizes the temperature setting.
Plasmacluster button and display
6.
Press to start / cancel the plasmacluster operation.
NOTE
The display for temperature setting and selected
compartment will turn off when there is no operation for
1 minute. (When either of buttons is pressed, it lights
again.)
The plasmacluster display stays alight.
Plasmacluster
The plasmacluster automatically starts operating when the
refrigerator is powered on.
To cancel operation
Press the "
" button (The light turns off).
To start operation
Press the "
" button again.
Notes about PLASMACLUSTER operation
The ionizer inside your refrigerator releases clusters of
ions, which are collective masses of positive and negative
ions, into the freezer and refrigerator compartments.
These ion clusters inactivate airborne mold fungus.
mold
fungus
There may be a slight odors in the refrigerator. This is the
smell of ozone generated by the ionizer. The amount of
ozone is minimal, and quickly decomposes in the
refrigerator.
Initial display for
freezer compartment
9
Temperature adjustment
The refrigerator controls its temperature automatically.
However, if needed, adjust the temperature as follows.
Refrigerator compartment
Adjustability from 0 °C to 6 °C in steps of 1 °C.
0 °C is the highest cooling temperature & 6 °C is the lowest
cooling temperature in the Refrigerator zone.
1
Press the select button.
lighting
2
Press the
/
button and set the temperature.
[
: increase,
: decrease ]
3
Press the "
" button.
Freezer Compartment
Adjustability from -13 °C to -21 °C in steps of °1C.
-21 °C is the highest freezing temperature & -13 °C is the lowest
freezing temperature in the freezer zone.
1
Press the select button.
lighting
2
Press the
/
button and set the temperature.
[
: increase,
: decrease ]
3
Press the "
" button.
Door Alarm
When the refrigerator or freezer door is left open, the door
alarm will sound.
• The door alarm will sound ۱ minute after opening the
door and again after ۱ minute (once in each case).
• If the door is left open for approx. ۳ minutes, the alarm
will sound continuously.
To cancel alarm signal
Press the select button continuously ۳ seconds or more while
holding down the "
" button.
It shows the door alarm stop.
It is the same method also when restarting the alarm signal.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sj-pc48a

Table of Contents