Fly.cutter/Arbor; Test.run - Grizzly G1007 Owner's Manual

fly cutter/arbor
all types of milling cutters and drill bits are
sharp. it is recommended that these not be
handled directly. use paper towels to hold
sharp tooling to avoid cuts to your hands.
be careful while handling them and store
them in a child safe location.
your Mill/drill comes equipped with a fly cutter
that fits on the 1" stub end of the r-8 arbor.
to install the fly cutter:
Clean all grease, oil and debris off the r-8
1.
arbor.
Clean all grease, oil and debris off the fly cut-
2.
ter.
Fit the fly cutter onto the stub end of the arbor
3.
so the keys on the arbor and the keyways on
the fly cutter come together (figure 23).
Flat Washer
Cap screw
figure 23. Fly cutter.
secure the fly cutter to the arbor with the cap
4.
screw and washer provided.
install the arbor with fly cutter into the Mill/
5.
drill as described in collet/arbor on page
21.
g1006/7 heavy duty Mill/drill
Fly Cutter
r-8 arbor
test run
once the assembly is complete, test run your
machine to make sure it runs properly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
troubleshooting on page 34.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
to test run the machine:
Connect the machine to the power source.
1.
Make sure you have read the safety instruc-
2.
tions at the beginning of the manual and that
the machine is setup properly.
Make sure all tools and objects used during
3.
setup are cleared away from the machine.
turn the machine ON.
4.
listen to and watch for abnormal noises or
5.
actions. the machine should run smoothly
with little or no vibration or rubbing noises.
— strange or unusual noises should be inves-
tigated and corrected before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.
turn the machine Off.
6.
-23-