Table of Contents
Advertisement
16
www.electrolux.com
Additional drying
Should the laundry still be too wet at the
end of the program, set another short
drying cycle.
The final part of a washer - dryer cycle
occurs without heat (cool down cycle).
This ensures the laundry will be left at
a low temperature.
WARNING!
To prevent the formation of creases
or shrinking of fabrics, avoid
excessive drying.
3.5 Settings
Save Favourite (
Program settings that are frequently used
can be saved (e.g. Cotton, 60°C, 1200
rpm, with Prewash and Vapour).
To program/re-program Favourite with
your own selections and save them,
proceed as follows:
1. Put machine in Stand-By mode.
2. Select your desired wash settings.
3.
To save favourite program, press and
hold "Hygienic Care (
about 2 seconds and you will hear
"Bip, Bip" sound and "
flashing on the display.
To recall the favourite wash program,
turn selector knob to "Favourite
program. You will get acknowledgement
on the display when the Favourite
program is loaded.
Child Safety Lock (
Your appliance is provided with CHILD
SAFETY LOCK which permits you to
leave the appliance unsupervised with
the door closed without having to worry
that children might be injured by or cause
damage to the appliance.
Set this option after pressing the
Start/Pause touchpad.
) Program
)" touchpad
" is
"
) Option
To set "Child Lock" option:
To activate the function, press and
hold "Prewash" and "Delay Start"
touchpads about 3 seconds until the
display shows the icon "
If you press any touchpad while
Child Lock is activated, the icon
"
" will flash on display
3 times along with buzzer sound.
The touchpads are locked
(except for the On/Off button).
This function remains enabled
even after the appliance is
switched off.
To deactivate the function, press and
hold "Prewash" and "Delay Start"
touchpads about 2 seconds until the
display shows the icon "
Extra Rinse Option
This option is recommended for people
who are allergic to detergents, and in
areas where the water is very soft. Use
this option to add two rinse phases to a
program.
To activate the option, press and hold
"Prewash" touchpad about 2 seconds
until the display shows the icon "
To deactivate the option, press and
hold "Prewash" touchpad about
2 seconds until the icon "
This option remains enabled even
after the appliance is switched off.
Enabling/Disabling End-Of-Wash
Buzzer
This setting permits you to either enable
or disable the buzzer at the end of the
program. As an example, you might wish to
disable this buzzer when you start a wash
when going to bed, so that when the wash
finished approximately 1 hour later, it will
not disturb you through the night.
".
".
".
" goes off.
Advertisement
Table of Contents
