Caution
• Turn on the monitor first before turning on the PC or
playback device.
• When switching the main power switch, the power switch or
the POWER button off and back on, always wait for at least
5 seconds. A short interval may result in a malfunction.
Turning on the main power
Main power switch
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main
plug.
Turning power on/off
Press the POWER button or POWER switch to turn the power
ON/OFF.
Status
Green lit
Orange lit
Green flashing
Turning Power On/Off
Power switch
Power LED
Status of the monitor
Power on
Power off (Standby mode)
Input signal waiting mode
nDate/time setting
• If the time has yet to be set when the monitor is first turned
on, the date/time setting screen appears. Set the date and
time.
DATE/TIME SETTING
/
/
01
/
01
/ 20
1. Press
or
to select the date and time, and
press
or
to change the numerical values.
2. Press
.
ENTER
• Be sure to set the date and time.
• The date/time setting screen will close automatically if
no operation is performed for about 15 seconds. The
date and time can be set using DATE/TIME SETTING
from the SETUP menu when the date/time setting screen
disappears.
TIPS
Set the date in "Month/Day/Year" order.
•
Set the time on a 12-hour basis.
•
The clock is maintained by the internal battery.
•
If you already set the time but the date/time setting
•
screen appears when the power is turned on, the
internal battery may be exhausted. Please contact an
authorized SHARP servicing dealer or service center for
assistance with battery replacement.
•
Estimated service life of the internal battery: About 5
years (depending on monitor operation)
•
The initial battery was inserted at the factory when the
monitor was shipped, so it may run out of power before
its expected operation life.
:
:
17
12
:
00
AM
OK···[ENTER] CANCEL···[RETURN]
7
E