Alcatel-Lucent OAW-AP277 Installation Manual page 8

Using the AP-270-MNT-H1 Mounting Kit
The OAW-AP277 access point can be installed on a wall or attached to a pole by using AP-270-MNT-
H1 mounting kit.
The OAW-AP277 access point does not ship with any mounting kit. The AP-270-MNT-H1 mounting kit is
available as accessories and must be ordered separately.
For details on AP-270-MNT-H1, please refer to the AP-270-MNT-H1 Installation Guide.
Mounting the OAW-AP277 Access Point to a Wall
1. Use the mounting template provided in the AP-270-MNT-H1 mounting kit package to mark the
four mounting points on the wall.
2. Use a drill to create four holes on the four markings you created in the previous step.
3. Insert an anchor bolt into each drilled hole. Anchor bolts are not included in the mounting kit
package.
4. Place the mounting bracket over the anchor bolts and press the bracket against the wall.
5. Place the washers and nut onto the bolt's threaded end and tighten the nut until the mounting
bracket is firmly attached to the wall as shown in
Figure 6 Attaching the Mounting Bracket to a wall
6. Use the M10x30 screw (with washer) and M10 nut included in the package to attach the mounting
holder to the mounting bracket as shown in
8
Figure 6.
Figure 7.
OAW-AP277 Outdoor Access Point
| Installation Guide