Mitsubishi Electric MXZ-3C30NA Service Manual page 67

10-2. AUTO LINE CORRECTING
Outdoor unit has an auto line correcting function which automatically detects and corrects improper wiring or piping.
Improper wiring or piping can be automatically detected by pressing the piping/wiring correction switch (SW871).
When improper wiring or piping is detected, wiring lines are corrected.
This will be completed in about 10 to 20 minutes.
[How to activate this function]
2. Check that the stop valves of the liquid pipe and gas pipe are open.
3. Check that the wiring between indoor and outdoor unit is correct.
(If the wiring is not correct, this function does not work.)
4. Turn ON the power supply and wait at least 1 minute.
5. Press the piping/wiring correction switch (SW871) on the outdoor control P.C. board.
Do not touch energized parts.
LED indication during detection:
LED1 (Red)
Lighted
LED indication after detection:
LED1 (Red)
Lighted
Once
Make sure that the valves are open and the pipes are not collapsed or clogged.
6. Press the switch to cancel.
LED indication after cancel :
LED1 (Red)
Lighted
NOTE : Indoor unit cannot be operated while this function is activated.
When this function is activated while indoor unit is operating, the operation will be stopped.
Operate indoor unit after the auto line correcting is finished.
Pressing the switch during detection cancels this function.
The record of auto line correcting can be confirmed in the following way:
Press the switch for more than 5 seconds.
LED will show the record of auto correcting for about 30 seconds as shown in the table below:
LED1 (Red)
Once
3 times
NOTE : Activate this function to confirm the correct wiring after replacing the outdoor control P.C. board.
(Previous records are deleted when the outdoor control P.C. board is replaced.)
The record cannot be shown if auto line correcting is not canceled (Refer to "How to activate this function").
OBH702E
LED2 (Yellow) LED3 (Green)
Lighted Once
LED2 (Yellow) LED3 (Green)
Not lighted Lighted
Once Once
Other indications
LED2 (Yellow) LED3 (Green)
Lighted Not lighted
Number of blinks
LED2 (Yellow) LED3 (Green)
Once Lighted
3 times Lighted
Indication
Completed (Problem corrected/ nomal)
Not completed (Detection failed)
located behind the service panel.
Wiring line
Not corrected
Corrected
67