Advertisement
Quick Links
INSTALLATION GUIDE
Alumina Lamp
Thank you for making the switch to Tala.
Discover the full Tala product family at tala.co.uk
BEFORE STARTING
Please read instructions thoroughly before installation and keep them
for future reference. Please take extreme care when dealing with
electrical equipment.
IMPORTANT
Bulb must be installed in fixture before turning on.
WARNING
Ensure power is turned OFF before inserting plug.
CARE AND CLEANING
We recommend cleaning with a soft dry cloth. Do not use abrasive
materials as these will damage the finish of the product.
WARRANTY AND AFTER-CARE
This product has a three-year warranty. If there appears to be a
functional defect with the product during this time, please contact our
team at customerservice@tala.co.uk. The external flexible cable or cord of
this luminaire cannot be replaced; if the cord is damaged, the luminaire
shall be destroyed.
IP20
220 - 240V
EU/UK
Advertisement
Related Manuals for Tala Alumina
Summary of Contents for Tala Alumina
- Page 1 This product has a three-year warranty. If there appears to be a functional defect with the product during this time, please contact our team at customerservice@tala.co.uk. The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed.
- Page 2 Table Configuration STEP 1 Insert your bulb into the top of the lamp, rotating clockwise until tight. Take care not to tighten too much to avoid breakage. STEP 2 Insert the lamp plug into your chosen wall socket, making sure the power is switched off.
-
Page 3: Wall Configuration
Wall Configuration STEP 1 Remove your bulb from the lamp, rotating counter clockwise and set aside. STEP 2 Remove the small lock screw from the side of the lamp with the hex key provided. STEP 3 Slide the lamp towards the cable to disconnect it from the base. - Page 4 STEP 4 Attach the lamp base to the wall using the orientation displayed below. Always choose screws and plugs that are appropriate for the wall, and ensure the wall cavity is free from electrical cables or piping before commencing drilling. STEP 5 (OPTIONAL) If you wish to hard wire the lamp into the household mains, please consult a...
- Page 5 STEP 6 Move the cable from the top to the bottom opening. STEP 7 Allign the lamp above the base and slide down to lock in place.
- Page 6 STEP 8 Insert your bulb into the front of the lamp, rotating clockwise until tight. Take care not to tighten too much to avoid breakage. STEP 9 Reattach the lock screw using the hex tool provided. Tighten until flush with the outside surface of the lamp .
- Page 7 STEP 10 Insert the lamp plug into your chosen wall socket, making sure the power is switched off. STEP 11 Switch the power on and rotate the dial on your dimmer until the bulb lights up. Adjust the dimmer for your desired light output.
- Page 8 Join the Community Instagram: @tala | Facebook: talaHQ | Pinterest: TalaLED | Tag: lighttoliveby Tala Studios, 25B Vyner Street, London E2 9DG | +44 20 3026 3246 | hello@tala.co.uk...