Over-The-Air Update; Wireless Connection Configuration - AEG T9DEE98PC User Manual

5.2 Over-the-air update

The App may propose an update for downloading new features.
The update is accepted via App only.
If a programme is running, the App notifies that the update will start
at the end of the programme.
During the update, the appliance shows
The appliance will usable again at the end of the update, without
any notification about successful update.
If an error occurs, the appliance shows
press any buttons or turn the knob to return to normal use.

5.3 Wireless connection configuration

Before you begin configuration download and install My AEG
application on your smart device.
1. Push the On/Off button to switch on the appliance.
2. Wait approximately 8 seconds.
3. Touch and hold down the Anticrease and Delay Start buttons at
the same time.
The symbols:
remains only flashing symbol:
around 1 minute. When ready the symbol:
appears on the display. Access Point is open around 3 minutes.
4. Configure My AEG application on your smart device.
If the configuration is successful the symbol:
disappears and the symbol:
Each time you switch the appliance on, the appliance attempt to
connect to the network automatically. When the connection is
established the symbol:
WI-FI - CONNECTIVITY SETUP
and appear on the display. After few seconds
stops flashing.
stops flashing.
in the display.
in the display: just
. Wireless module is activating
(Access Point)
(Access Point)
17/64