Kenwood C-707i-S Instruction Manual page 81

Device connected to the [iPod] terminal
Symptoms
iPod is not recognized.
Cannot control the iPod.
Poor response.
Remote control
Symptoms
The remote control
does not work.
Resetting the microcomputer
Symptoms
Microcomputer
malfunction (the system
does not work, the
display is faulty, etc.).
en12_c-707i.indd 81 en12_c-707i.indd 81
Solution
Connect with a PNC-iP120 iPod connection cable
(optional accessory).
Connect the PNC-iP120 iPod connection cable
securely.
Check that the iPod model is compatible for playback
by the system.
Disconnect the iPod from the system, disconnect all
devices from the iPod, and then re-connect it to the
system.
Check that the iPod model is compatible for playback
by the system.
iPod response becomes poor when there is a large
number of tracks on the iPod. This is particularly true
when shuffl e is turned on for a large number of tracks,
which can cause poor response of the iPod itself.
Solution
Load new batteries.
Use the remote control within its eff ective range.
Reset Procedure (Main unit only)
1 Turn off the power (press the [K] key to enter Standby mode).
2 While holding down the [H] and [STOPF] keys on the main unit, hold
down the main unit's power [K] key until the message "CLEAR ALL" appears
on the display.
Remember that resetting erases any stored information and restores the
system's default settings.
Ref. page
Ref. page
Solution
Troubleshooting
17
17
27
17
27
27
21
21
81
English
12/26/2007 10:48:25 AM 12/26/2007 10:48:25 AM