EmberGlow VFF26NLMA Owner's Operation And Installation Manual page 11

Back of Fireplace
DO NOT use an off the shelf 3/8"
NPT pipe plug. This will damage
the plungers located inside the
regulator.
WARNING: Do not allow any
combustible materials to overlap
the firebox front.
WARNING: Do not allow
combustible or noncombustible
materials to cover any necessary
openings like louvered slots.
WARNING: Never modify or
cover the louvered slots on the
front of the firebox.
Built-in installation of this fireplace involves
installing fireplace into a framed-in enclosure.
This makes the front of the fireplace flush
with wall. If installing a built-in mantel above
the fireplace, you must follow the clearances
shown in Figure 7.
NOTICE: Surface temperatures
of adjacent walls and mantels be-
come hot during operation. Walls
and mantels above the fireplace
may become hot to the touch. If
installed properly, these tempera-
tures meet the requirement of the
national product standard. Follow
all minimum clearances shown in
this manual (see Figure 8).
200252-01A
INSTALLATION
BUILT-IN FIREPLACE INSTALLATION
www.sureheat.com
DO NOT try to remove the plung-
ers from inside the regulator. The
plunger will be pushed back as
the fitting is installed.
Make sure the type of gas being
used is correct. Check to make
sure the connection fitting is in
the correct inlet on the regula-
tor. Refer to Connecting to Gas
Supply, page 13.
If you are using natural gas
and the pilot will not light, see
Troubleshooting, page 22.
3/4" Clearance to Facia
1 / " Clearance to Sides, Back and Top
3
8
Note: Height of fireplace opening on facia to be 23
Figure 7 - Clearance to Combustibles
Note: All vertical
measurements
are from top of
fireplace
opening to
bottom of
mantel shelf. All
measurements
are in inches.
Side of
Firebox
Figure 8 - Fireplace Clearances
27 / "
3
4
28 / "
3
4
Mantel
10" Shelf
8"
6"
2 / "
1
2
/ "
1
4
11