Cleaning Vent Grille (Oven Air Vent); Installing Vent Grille - Panasonic NN-SD291W Operating Instructions Manual

IP4924_39X05CP_Eng_00_140417:IP3677_38Q04CP_00_110608.qxd 2014-4-17 10:11 Page 27
Care and Cleaning of your microwave Oven

Cleaning vent grille (Oven Air vent)

1. Moisten a soft cloth in hot water containing mild detergent.
2. Wipe the front surface gently.
3. tilt the Grille cover forward slowly as shown in Fig. a.
4. Wipe inside the Grille cover.
to avoid the risk of injury when cleaning, DO nOt directly
contact the metal edges of the Grille cover.
for Non-vented (ductless) application only.
Charcoal filter Replacement (NN-Cf203)
this product is shipped for use in the top exhaust ventilation
mode. If you wish to install this product without using an
exhaust duct, the exhaust must be recirculated through the
front louver and a charcoal filter. a temporary charcoal filter
has been installed for your convenience. however, we
recommend that this filter be changed as soon as possible
with the replacement charcoal filter kit (nn-CF203) that can be
purchased from your local Panasonic dealer. the charcoal
filter cannot be cleaned. Once the replacement filter has been
installed, it should be replaced periodically every 6 to 12
months, or more often if necessary. Refer to the following
instructions for replacement.
1. Remove the vent grille
Pull the front louver down to open as shown in Fig. B.
Remove two screws from the front and one from the top,
then pull the Vent Grille forward.
Screws
2. Remove the temporary Charcoal filter
Insert your finger under the bottom of the filter, and pull the
Charcoal Filter forward as shown in Fig.C.
(Fig. A)
(Fig. B)
(Fig. C)
3. Install replacement Charcoal filter (NN-Cf203)
Install the Charcoal Filter aligning the two holes, then secure
with two screws as shown in Fig. D.
Screw

Installing vent grille

1. Slide the top flange of Grille along the top plate, then tilt the
Grille down to fit as shown in Fig. e.
Top flange of Grille
(Fig. E)
2. tilt the front louver downwards, then secure with three
screws, one on each side and one on top as shown in
Fig. F.
Screws
27
(continued)
Screw
(Fig. D)
Top Plate
(Fig. F)