Table of Contents
Advertisement
Indoor unit installation
Wall mounting brackets and dimensions
100/3.9
120mm/4.7in
or more to wall
Left rear side
refrigerant pipe
hole Ф65/2.6in
Installing the Wall Mounting Bracket
1. Install the wall mounting bracket
horizontally over the structural
parts on the wall using the spaces
indicated on the bracket, as shown
in figure 1.3.
2. In the case of tiled, concrete or
similar walls, create 13/64"
diameter holes. Place anchor
supports for the appropriate
assembly screws.
3. Install the wall mounting bracket to
Attention!!!
Fit the wall mounting bracket and drill holes in the wall according to the
wall structure and corresponding mounting points on the wall mounting
bracket (Dimensions are in "inches" unless otherwise stated).
Drilling the Hole
1. Determine the position of the
hole for the pipes using the wall
mounting bracket and drill the
pipe hole so that it is tilted slightly
downward.
2. Always use a pipe cover with an
opening when drilling.
150mm/5.9in or more to ceiling
800/31.5
95/3.7 Indoor unit outline
the wall with 5 self-tapping screws.
4. At all times securing to the wall
studs is recommended.
Wall mounting bracket
Figure 1.3
Wall
Indoor unit
Indoor unit installation
120mm/4.7in
or more to wall
Right rear side
refrigerant pipe
hole Ф65/2.6in
Outdoor unit
08
Advertisement
Table of Contents
