IMPORTANT SAFETY INFORMATION
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Do not exceed the maximum hydraulic flow,
pressure relief or back pressure listed in the
Specifications and Parts manual.
Failure to observe this warning could result in
severe injury or death.
Do not disconnect tool, hoses, or fittings while
the power source is running or if the hydraulic fluid
is hot. Hot hydraulic fluid could cause serious burns.
Greenlee / A Textron Company
H4670/42192 Submersible Trash Pump
Hydraulic oil can cause skin irritation.
• Handle the tool and hoses with care to prevent
skin contact with hydraulic oil.
• In case of accidental skin contact with hydraulic
oil, wash the affected area immediately to remove
the oil.
Failure to observe these precautions may result
in injury.
Do not reverse hydraulic flow. Operation with
hydraulic flow reversed can cause tool malfunction.
Connect the supply (pressure) hose and return (tank)
hose to the proper tool ports.
Procedure for disconnecting hydraulic hoses, fittings
or components:
1. Move the flow lever on the hydraulic power
source to the OFF position.
2. Stop the power source.
3. Follow the sequence under Disconnecting
Hoses to prevent pressure buildup. In case
some pressure has built up, loosen hoses,
fittings or components slowly.
Note: Keep decals clean and legible. Replace decals
when necessary—see the decals listed in the Parts and
Specifications manual.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070