Mounting; Orientation; Rigging; Manual Focusing - Chauvet DMX-250C User Manual

Mounting

O RI ENT AT I O N
This fixture may be mounted in any position provided there is adequate room for ventilation.
RI G G I NG
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable "C" or "O" type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.

When selecting installation location, take into consideration lamp
replacement access and routine maintenance.

Safety cables should always be used.

Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.

Manual Focusing

To adjust the focus, please follow the instructions below.
1) If operating in stand alone mode, turn the music
down so that the unit temporarily stops any activity,
other wise turn the lamp on using Channel 4.
2) Rotate the lens gun either clockwise or counter-
clockwise until the spot is defined by a hard edge.

Fuse Replacement

With a flat head screwdriver wedge the fuse
holder out of its housing. Remove the damaged
fuse from its holder and replace with exact
same type fuse. Insert the fuse holder back in
its place and reconnect power.
DMX-250C User Manual
Disconnect the power cord before replacing a fuse and
always replace with the same type fuse.
7
Figure 2 - Hanging Clamp
Note!
Clamp is sold separately.
Rotate lens gun
clockwise and
counter-clockwise
to achieve desired
focus.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
Revision: 5/17/2005 10:49 PM
Setup
IN OUT