Walk Assist - TQ-Systems Display V02 User Manual

Table of Contents

Advertisement

9

Walk assist

The walk assist makes it easier to push the e-bike, e.g. off-road.
NOTE
— The availability and characteristics of the walk assist are subject to coun-
try-specific laws and regulations. For example, the assistance provided
by the push assist is limited to a speed of max. 6 km/h in Europe.
— If you have locked the use of the walk assist in setup mode (see section
"„5.2 Settings""), the next screen with riding information is Displayed
instead of activating the walk assist (see chapter "„6 Riding informa-
tion"").
Activate walk assist
CAUTION
Risk of injury
► Make sure that both wheels of the e-bike are in contact with the ground.
► When the walk assist is activated, make sure that your legs are a suffi-
cient safety distance from the pedals.
► When the e-bike is at standstill, press the UP button on the Remote for
longer than 0,5 s (see Fig. 9) to
activate the walk assist.
► Press the UP button again and
keep it pressed to move the e-bike
with the walk assist.
Deactivate walk assist
The walk assist is deactivated in the
following situations:
— Press the DOWN button on the Remote control (pos. 2 in Fig. 2).
— Press the button on the Display (pos. 5 in Fig. 1).
— After 30 s without actuation of the walk assist.
— By pedaling.
EN - 16
Fig. 9:
Activate walk assist
>0,5 s

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Display V02 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Remote v01

Table of Contents