Hcec Setup - LG LT340H0S Series Installation Manual

HCEC Setup

1 Go to →
General HCEC
(1) HCEC Setup
• When HCEC Setup is set to
SIMPLINK feature automatically changed to the on state, and the user can not change this status.
(a) IR Decoding
CEC Mode
• When
it to Command via the HDMI CEC Line. The default value is Disable.
(b) Device ID
• Sets the ID of a device(Logical Address) connected to the CEC Line. You can choose between
E.
• The default value is All.
(c) Stand By
• Sets the sending and receiving scenario of the operation about [CEC Op standBy(0x0c)
Command(Device Power)].
• The detailed scenario is described on the table below.
Receive Only
(2) HTNG HotelMode
• If the following options are selected because of the HTNG command:
* Power On Default, Start
HotelMode
changes automatically to
options are still affected.
• If you change it to Disable, then the values set by the HTNG will be canceled.
Setup.
CEC Mode, You can adjust
HCEC Mode, the TV decodes and changes it into a CEC Message and sends
is set to
Send Only
All
Off
Volume, Maximum Volume,
Enable and, even if the HotelMode is set to Disable, the above
IR Decoding, Device
Send Receive
O
X
O
X
Minimum Volume, then the value for the
ID, StandBy menu and
All
X
O
O
X
HTNG
25
and