Turn On; Adjust The Volume Level - Philips AE5020/12 User Manual

Table of Contents

Advertisement

Option 2: Battery power
Caution
Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire or
the like.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same equivalent type.
Do not mix batteries (old and new or carbon and
alkaline, etc.).
Remove batteries if they are exhausted or if the unit is
not to be used for a long time.
1
Open the battery compartment at the
back of the unit.
2
Insert four R14/UM-2/C size batteries
(not supplied) with correct polarity
(+/-) as indicated, then close the battery
compartment.
» The unit is ready to operate.
Caution
A 'Battery low' message is shown when the battery
power is low. Replace batteries or connect to AC
power to ensure normal operation.
Note
Batteries contain chemical substances, so they should
be disposed of properly.

Turn on

/VOL +/- clockwise until you
Rotate
hear a click to turn on the unit.
» The unit switches to the last selected
source.
» For first-time use, the unit shows a
welcome message and switches to
DAB mode to start automatic scanning
for available DAB stations.
To turn off the unit:
/VOL +/- anticlockwise until you
Rotate
hear a click.

Adjust the volume level

During radio broadcast, rotate
+/- clockwise/anticlockwise to increase/
decrease the volume level.
/VOL
EN
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ae5020

Table of Contents