Napoleon ROGUE RSE525RSIB Manual page 17

Problem
Humming regulator.
Burners will not cross
light each other.
"Paint" appears to be
peeling inside lid or hood.
Burner output on
"high" setting is too
low. (rumbling noise
and fluttering blue flame
at burner surface.)
Infrared burner (if
equipped) flashes back
(during operation the
burner abruptly makes
a loud "whoosh" sound,
followed by a continuous
blow-torch type sound
and grows dim.)
N415-0567 Mar 26.20
Possible Causes
Normal occurrence on hot days.
Dirty or corroded cross
light brackets.
Grease build-up on
inside surfaces.
Lack of gas.
Supply hose is pinched.
Dirty or clogged orifice.
Spider webs or other
matter in venturi tube.
Propane regulator in
"low flow" state.
Ceramic tiles overloaded
with grease drippings and
build-up. Ports are clogged.
Burner overheated due to
inadequate ventilation (too
much grill surface covered
by griddle or pan.)
Cracked ceramic tile.
Leaking gasket surrounding
the ceramic tile, or a weld
failure in the burner housing.
Solution
This is not a defect. It is caused by
internal vibrations in the regulator
and does not affect the performance
or safety of the gas grill. Humming
regulators will not be replaced.
Clean or replace as required.
This is not a defect. The finish on
the lid and hood is porcelain, and
will not peel. The peeling is caused
by hardened grease, which dries
into paint-like shards, that flake
off. regular cleaning will prevent
this. See cleaning instructions.
Check gas level in propane cylinder.
reposition supply hose as necessary.
Clean burner orifice.
Clean out venturi tube.
Ensure lighting procedure is followed
carefully. all gas grill valves must
be in the off position when the
tank valve is turned on. Turn tank
on slowly to allow pressure to
equalize. See lighting instructions.
Turn burner off and allow to cool
for at least two minutes. relight
burner and burn on high for at least
five minutes or until the ceramic
tiles are evenly glowing red.
Ensure that no more than 75%
of the grill surface is covered by
objects or accessories. Turn burner
off and allow to cool for at least
two minutes, then relight.
allow burner to cool and inspect
very closely for cracks. If any
cracks are found, contact your
authorized Napoleon dealer to order
a replacement burner assembly.
Contact your authorized Napoleon
dealer for instructions on ordering
a replacement burner assembly.
17
EN
www.napoleon.com